Autodesk InfraWorks for Engineering Design
Duration: 02 day(s)
Note: This course is based on the April 2017 release of the Autodesk InfraWorks software. There might be slight differences between the software used in this learning guide and other versions of the software.
The Autodesk InfraWorks for Engineering Design training course is designed for people using any of the following software packages:
  • Autodesk InfraWorks
  • Autodesk Architecture, Engineering and Construction Collection
The training course provides you with a fundamental knowledge of the accelerated design process that uses data-rich 3D models with high-end visualizations. This enables you to create, evaluate, and better communicate 3D site plan proposals for faster approvals.

Topics covered in this Autodesk InfraWorks training course:
  • Roadway Design:
    • Create property boundaries for parcels, easements, and right-of-ways
    • Create and modify design roads with precise parameters
    • Design a road using component roads
    • Adjust roadside grading
    • Apply and review suprerelevations in component roads
    • Modify how design roads intersect using a standard intersection or roundabout
    • Optimize the vertical design of a roadway
    • Create gradient maps based on selected feature sets to identify areas with low impact for site or corridor optimization (Preview)
    • Find an optimal horizontal design of the roadway which yields a cost effective and environmentally-friendly solution (Preview)
    • Run traffic simulation to analyze and animate design traffic (Preview)
  • Bridge Design:
    • Add bridges to a design roadway
    • Work with bridge deck and girder cross sections
    • Perform analysis and design checks on all the pre-stressed girders of your bridge (Preview)
  • Drainage Design:
    • Run a watershed analysis
    • Create or modify culverts
    • Create a pavement drainage network
    • Analyze the pavement drainage network
  • Point Cloud Modeling:
    • Preparing the point cloud
    • Create a terrain from a point cloud
    • Create features from a point cloud

Prerequisites for this Autodesk InfraWorks training course:
A fundamental understanding of how to navigate the Autodesk InfraWorks software. This includes how to create new models, add and modify features to those models.
It is recommended that you first take the Autodesk InfraWorks Fundamentals for Conceptual Design & Visualization training course.

Course description shown for Autodesk InfraWorks 2018.
Topics, curriculum, and/or prerequisites may change depending on software version.